Start liking this
Description:
>b>Directions: >/b>To Open: Unfold head and feet sections until locking tub tabs snap securely into place. Test locking mechanism by lifting up each section. To Use: Place tub completely in a single or double sink or on a flat surface. Test tub stability in sink by pushing down on ends and by pushing side to side. Run 1 to 2 inches of warm water in center section of the tub. Make sure you have all bathing needs before placing baby in tub. To Drain: Flip up drain plug. To Clean: Rinse thoroughly after using. Squeeze excess moisture from foam pad and air dry thoroughly before closing to store. To Close: Push locking tabs at side, then fold ends up in toward the center. Tub should be supported by bottom of sink. Tub must fit in sink.




